Because if you wait too long to do the scrub, the grout sets up too much and gets really hard to remove. I work with a bucket of clean water nearby so that I can rinse my sponge out and ring out the excess water before every fresh pass with the sponge.Ī couple more tips on this step: for the sharpest (and smallest) grout line, lightly scrub the grout until the full tile edge is revealed. This is also the time to do some QC on your grout job so fill in any places you missed with a bit of grout using your finger. I also recommend setting yourself a timer while the grout is setting. ![]() You also want to make sure your sponge is just damp and not wet because introducing too much water will re-hydrate the grout and you'll have to repeat this step again. The goal here is to remove excess grout from the surface of the tiles and not dig into the grout lines, so work with gentle pressure on the sponge. Then gently scrub the surface of the tiles with a damp sponge. Once the first section of tile has been completely grouted, wait 10-15 minutes (or whatever your grout manufacturer recommends) for the grout to lightly set. Tip: In most cases plumbing goes in after framing but sometimes it's much easier to frame around the drain lines and that's what we did here! The tub filler and shower risers were plumbed with copper (not PEX per the manufacturers recommendations) but we connect the hot and cold supplies with PEX for simplicity. The tub filler is 3" above the tub edge and the shower outlet is 6'10" above the tub floor. We selected the Delta Trinsic fixtures and like other manufactures, Delta has a universal rough-in valve body that we mounted 28" from the tub floor. This is also the time to layout the fixtures and connect the supply lines to mixing valve. ![]() You'll notice we added a 60° ABS fitting to the overflow and this was because on the Kohler Bellwether (which we absolutely love), the overflow outlet sits in a sloped surface and we needed this extra angled piece to connect to the drain. ![]() Even so, we did still need to chip out ~2" of concrete below to allow for the p-trap. Tub drain kits come with (almost) everything needed to connect the tub and overflow to the p-trap. We used 2圆" studs and a 3/4" plywood topper to raise the tub just over 6" above the slab. We installed the tub on an existing concrete slab and rather than cut, dig and re-plumb, we opted to elevate the tub on a platform to connect our drain to the existing pluming. Marshalltown Grout Float Step 1 // Plumbing + Installing the Tub DIY: Tile Shower Surround Time: 3+ Days Materials:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |